The impact of insecticides containing deltamethrin and cyfluthrin on the composition of surface compounds in the larvae,females and males of Tenebrio molitor

This paper presents the effect of insecticides on the composition of the surface compounds of one of the most harmful insects, Tenebrio molitor, by analysis using GC–MS. As a result of the use of insecticides, the composition of the chemical compounds on the surface of insects changes, depending on the insecticides used. The most numerous groups of the marked compounds were fatty acids, alkanes, esters and sterols. The content of the identified compounds in the larvae increased at both 24 and 48 h after the application of insecticides, in comparison with the control samples. The content of identified compounds in the samples taken from the females increased 24, 48 and 72 h after the application of insecticides in comparison with the control samples. By contrast, in samples prepared from males, the content of identified compounds decreased 24 h after the application of insecticides, compared with the control samples. The highest content of chemical compounds was for fatty acids and alkanes after the use of insecticides. The content of fatty acids after the application of the insecticide with deltamethrin was 62.1 ± 3.3–466.9 ± 5.9 μg/g, and after the application of the insecticide with cyfluthrin was 49.9 ± 1.9–458.3 ± 4.2 μg/g. However, the content of alkanes after the use of deltamethrin was 115.6 ± 4.2–4672.0 ± 32.1 μg/g, and after the use of cyfluthrin was 189.4 ± 3.8–3975.0 ± 10.2 μg/g.     

Trace-level analysis of polychlorinated biphenyls,organochlorine pesticides and polycyclic aromatic hydrocarbons in human plasma or serum by dispersive liquid–liquid microextraction and gas chromatography–tandem mass spectrometry

A method to determine 8 polychlorinated biphenyls (PCBs), 23 organochlorine pesticides (OCPs) and 16 polycyclic aromatic hydrocarbons (PAHs) was described using dispersive liquid–liquid microextraction (DLLME) of a small amount of plasma or serum sample and gas chromatography–tandem mass spectrometry (GC–MS/MS). The appropriate selection of the extraction solvent and dispersing solvent contributes to a high extraction yield and a clean extract. To verify the developed method, the interference, linearity of the calibration curve, detection limit, precision and accuracy were evaluated. The calibration curves were linear by 2–3 orders of magnitude with correlation coefficients above 0.997 in all cases. The LODs of PCBs, OCPs and PAHs were measured in the ranges of 0.0006–0.0029, 0.001–0.029 and 0.0002–0.012 ng/mL. The intraday precision achieved by this method was 2.19–10.3% (PCBs), 1.65–14.3% (OCPs) and 0.91–12.8% (PAHs), and the intraday accuracy 1.56–7.37% (PCBs), 2.34–19.6% (OCPs) and 1.49–15.7% (PAHs). The advantage of this method is that the analysis of PCBs, OCPs, and PAHs can be performed in a single chromatographic run, and the low detection limit enables monitoring of target substances in low exposure general public samples, and the analysis procedure is relatively simple and fast.     

Developing the Low-Temperature Oxidation Mechanism of Cyclopentane: An Experimental and Theoretical Study

At present, the reactivity of cyclic alkanes is estimated by comparison with acyclic hydrocarbons. Due to the difference in the structure of cycloalkanes and acycloalkanes, the thermodynamic data obtained by analogy are not applicable. In this study, a molecular beam sampling vacuum ultraviolet photoionization time-of-flight mass spectrometer (MB-VUV-PI-TOFMS) was applied to study the low-temperature oxidation of cyclopentane (CPT) at a total pressure range from 1–3 atm and low-temperature range between 500 and 800 K. Low-temperature reaction products including cyclic olefins, cyclic ethers, and highly oxygenated intermediates (e. g., ketohydroperoxide KHP, keto-dihydroperoxide KDHP, olefinic hydroperoxides OHP and ketone structure products) were observed. Further investigation of the oxidation of CPT – electronic structure calculations – were carried out at the UCCSD(T)-F12a/aug-cc-pVDZ//B3LYP/6-31+ G(d,p) level to explore the reactivity of O₂ molecules adding sequentially to cyclopentyl radicals. Experimental and theoretical observations showed that the dominant product channel in the reaction of CPT radicals with O₂ is HO₂ elimination yielding cyclopentene. The pathways of second and third O₂ addition – the dissociation of hydroperoxide – were further confirmed. The results of this study will develop the low-temperature oxidation mechanism of CPT, which can be used for future research on accurately simulating the combustion process of CPT.     

Simultaneous determination of novel β-lactamase inhibitor WCK 4234 and Meropenem in dog plasma by LC–MS/MS and its application to preclinical pharmacokinetic study

A precise and accurate liquid chromatography–tandem mass spectrometric (LC–MS/MS) bioanalytical method has been developed and validated for the simultaneous quantification of WCK 4234 and meropenem (MEM) in dog plasma. Protein precipitation using acetonitrile was employed as a sample preparation approach. Cefepime was used as an internal standard. The developed method was selective, sensitive (limit of quantification, 0.075 μg/ml for both drugs), accurate (recovery > 90%), precise (CV < 10%) and linear (r² ≥ 0.99, concentration range 0.075–120 μg/ml for both analytes). The developed method was successfully applied for the determination of both drugs in plasma to assess the pharmacokinetics in beagle dogs. WCK 4234 + MEM in a 1:1 ratio at 15 + 15 and 30 + 30 mg/kg doses were administered by the intravenous route. The mean plasma concentration and area under the concentration–time curve of WCK 4234 ranged from 38.3 to 77.4 μg/ml and from 47.8 to 77.1 μg h/ml, respectively, and the values for MEM ranged from 52.2 to 115.3 μg/ml and 70.5 to 133.6 μg h/ml respectively. The elimination half-life of WCK 4234 and MEM was around 0.8 h.     

Modified layered bimetallic compound used as a novel adsorbent for the solid-phase extraction of monoaromatic hydrocarbons from water samples prior to gas chromatography–mass spectrometry

This study reports a promising method of solid-phase extraction for determining the toluene, ethylbenzene, p-xylene, m-xylene, o-xylene, 1,3,5-trimethylbenzene, and 1,2,4-trimethylbenzene in water samples by gas chromatography–mass spectrometry (GC–MS). Prior to this procedure, the magnesium–aluminum bimetallic hydroxides modified with sodium dodecylbenzenesulfonate (Mg/Al-SDBS-LDH) were prepared and served as the novel solid-phase extractant. The Mg/Al-SDBS-LDH has advantage of good hydrophobicity and larger spacing which facilitates the monoaromatic hydrocarbons (MAHCs) into the interlayer for adsorption. As a result, the seven MAHCs in 500 mL water samples were enriched greatly, and the theoretical enrichment factor reached to 125 times. Under the optimized conditions of solid-phase extraction (SPE) and GC–MS, the mass concentration of each MAHC (0.005–10, 0.01–10, or 0.05–10 ng/mL) had a fine linear relationship with peak area. The correlation coefficients were more than 0.995. The detection limits were between 0.001 and 0.01 ng/mL, and the RSD were between 3.1% and 6.6%. The method had been applied to determine the seven MAHCs in the Dongfengqu river water and laboratory wastewater of Chengdu University of Technology successfully.     

氩气感应耦合等离子体速度与温度数值模拟

为了获得用于研究再入飞行器热防护系统的感应耦合等离子体风洞流场数据，基于流场、电磁场和化学场的多场耦合建立了非平衡态感应耦合等离子体数值模型。利用该模型对不同入口质量流率和不同工作压力下的感应耦合等离子体进行了数值模拟，得到了相应工作参数下感应耦合等离子体温度与速度的分布特性。计算结果表明：等离子体中心线上的速度随着入口质量流率的增大而增大，而随着工作压力的增大而减小；同时，等离子体中心线上的温度随着入口质量流率的增大而减小，而随着压力的增大先减小后增大。这些结果可为感应耦合等离子体风洞优化设计及其工业应用提供理论指导。     

X射线荧光光谱法测定重整铂催化剂中氯

建立重整铂催化剂中氯的X射线荧光光谱测定方法。通过研磨机将铂催化剂研磨至粒径小于75 μm的颗粒,采用仪器压片制样,通过测量不同氯含量样品的计数率,建立铂催化剂中氯含量与计数率的线性关系。氯的质量分数在0.85%~1.04%范围内与计数率成良好的线性关系,相关系数为0.9995,检出限为0.0076%。样品加标回收率为96.2%~104.2%,测定结果的相对标准偏差小于2%(n=6)。该法测定结果与电位滴定法相吻合。该方法精密度高,分析速度快,满足重整装置生产调整的要求。     

Ultrasound wave assisted removal of Ceftriaxone sodium in aqueous media with novel nano composite g-C3N4/MWCNT/Bi2WO6 based on CCD-RSM model

The aim of this study was ultrasound assisted removal of Ceftriaxone sodium (CS) based on CCD model. Using sonochemical synthesized Bi₂WO₆ implanted on graphitic carbon nitride/Multiwall carbon nanotube (g-C₃N₄/MWCNT/Bi₂WO₆). For this purpose g-C₃N₄/MWCNT/Bi₂WO₆ was synthesized and characterized using diverse approaches including XRD, FE-SEM, XPS, EDS, HRTEM, FT-IR. Then, the contribution of conventional variables including pH, CS concentration, adsorbent dosage and ultrasound contact time were studied by central composite design (CCD) under response surface methodology (RSM). ANOVA was employed to the variable factors, and the most desirable operational conditions mass provided. Drug adsorption yield of 98.85% obtained under these defined conditions. Through conducting five experiments, the proper prediction of the optimum point were examined. The respective results showed that RSD% was lower than 5% while the t-test confirmed the high quality of fitting. Langmuir isotherm equation fits the experimental data best and the removal followed pseudo-second order kinetics. The estimation of the experimentally obtained maximum adsorption capacities was 19.57 mg.g⁻ of g-C₃N₄/MWCNT/Bi₂WO₆ for CS. Boundary layer diffusion explained the mechanism of removal via intraparticle diffusion.     

Mass‐Spectrometric Observation of Counter Anion Production in SU‐8 Exposed to UV Light and its Use for Dill C Parameter Determination

Photopolymerization is a phenomenon that is the basis of much of today's microfabrication technology and intense research is conducted to improve its control and the characteristics of end products for a variety of applications. The design of microscopic structures often relies on the accurate knowledge and modeling of photopolymer's behavior upon exposure, i.e. the Dill parameters, for each radiation species of interest and therefore the development of flexible characterization techniques is of great importance. SU‐8 is a popular compound that is representative of a whole class that relies on cationic polymerization, where an acid is obtained via photolysis of an onium salt during exposure. Here we report on the observation of SbF₆^? via laser desorption mass spectrometry on SU‐8 exposed to UV light at the wavelength of 365 nm and demonstrate that the yield of this counter‐anion as a function of exposure is consistent with the Dill C parameter value available in the literature. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019 , 57, 967–972